@ Jaypee 2003

 PEA BRACKETS 0.022 SLOT 

                                                   
                                              

300-101

 

 Aesthetic PEA Bracket system.

Roth 0.022 prescription.

 

Made out of hard , non abrading , non toxic , biocompatible translucent material.

Brackets have excellent resistance to discoloration.

Friction is less than stainless steel brackets.

 

 Extra hardness minimises the bracket wear during tooth movement

Unique low chamfer, torque in base, rhombodial bracket design prevents distortion of 

the bracket due to occlusal force and force application during tooth movement.

The integrated mesh like design gives retention as good as Stainless steel mesh 

brackets.

Rebonding of the bracket is possible after removing the adhesive from bracket  with 

 

 No Silane required for bonding. Bond Strength can be enhanced by conditioning the

bracket base with toluene monomer before bonding.

Smooth rounded hooks on cuspid and bicuspid brackets.

Tip & Torque values have been compensated for loss during tooth movement.

The brackets are color coded at the disto gingival wing for easy identification.

Available in kits of 20 brackets from 5 to 5.

 

 Larger Kits & Loose brackets available upon request.

Very competitively priced

COLOR CODING      :     UL - RED   UR - BLUE   LL- YELLOW     LR - GREEN

 

SPARKLE  TIP AND TORQUE VAULES - ROTH
5 4 3 2 1   1 2 3 4 5
-7 -7 -2 +8 +12 Torque +12 +8 -2 -7 -7
0 0 +13 +9 +5 Tip +5 +9 +13 0 0
UPPER LEFT UPPER RIGHT
LOWER LEFT LOWER RIGHT
0 0 +7 0 0 Tip 0 0 +7 0 0
-22 -17 -11 0 0 Torque 0 0 -11 -17 -22
5 4 3 2 1   1 2 3 4 5

STEP WISE BONDING PROCEDURE FOR SPARKLE

Step  1. Etch the tooth with an etchant.

Step  2. Air dry the tooth surface.

Step  3. Apply primer on the tooth surface with a brush.

Step 4. Apply a conditioner on the bracket base (Cold cure Monomer) or any commercially available composite conditioner. Use a separate brush for applying monomer. Use of same brush for applying primer and monomer will result in gelling or setting of primer

Step  5. Apply the primer on the bracket base over the conditioner . There is no need to wait for drying . Primer can be applier on wet or freshly applied monomer.

Step  6.  Apply paste over the bracket base and place the bracket on the tooth, wait for 90 seconds for paste to set . The conditioner is to be applied to the bracket base even lf the bonding adhesive is light cured . The curing can be done after placement of all the brackets. Sparkle has distinct advantage over metal bracket when light cure bonding is used because the unique material used to make the bracket permits light penetration through the bracket giving a better bond strength.

In case of bond failure bracket rebonding can be done after cleaning or removing the adhesive for the  bracket base with a straight fissure micromotor bur and then following the bonding procedure mentioned above.

Bracket recycling is not recommended.